Transfer Die using a Progressive Tool Company In Die Transfer system.
Designed & Created by Progressive Tool Company

Special Features:
• Low Cost
• Low Maintenance
• Ball Bearing slides for long life and low friction
• Replaceability - most components are standard purchased items
• Transfer bars and fingers produced on CNC equipment for accurancy
• Requires less shut height because of low profile
• Can be mounted in the die for permanent use or as a removeable unit
• In die mounting allows for setup and debugging in the tool room
• Transfer system can be ran outside the press with part samples
• Transfer motion is actuated by one signal from the press in run mode
• Transfer can be single stroked for die tryout in the press
• Any part jam-ups can be cleared easily by turning off air supply
• Self contained transfer tool only requires connecting air for set up
• Can be reused in a different tool if part becomes obsolete

Mechanical Features:
• Air operated with 40-50lbs. of air
• Complete air logic system built in requires on signal from press
• Adjustable speed on fingers and pitch
• Adjustable pitch in each direction to position parts accurately
• Adjustable finger travel for accurate gripping of parts

System Specifications:
• Speeds: Up to 40 SPM
• Standard Pitches: Up to 24 inches
• Pitch Accuracy: +/- .020
• Standard Finger Travels: Up to 6 inches
• Finger Grip Accuracy: +/- .020
• Standard Passline: 12 inches minimum

Design Features:
• All designs are done on CAD for replaceability
• Provide the design of the transfer and the tooling for a turnkey product
• Designed by die designers with many years of experience in die building